PLASMA
FIBROBLAST

Our new revolutionary non surgical lift treatment is a remarkable alternative to surgical methods.


HIGH ENERGY TREATMENT: ($300-$500)

  • PLASMA ENERGY TOUCHES THE SKIN FOR APPROXIMATELY 0.5 S;

  • THE AREA OF THE SKIN TREATED IS RELATIVELY LARGE, E.G. UPPER EYELID;

  • THE DENSITY OF PLASMA SPOTS IS HIGHER THAN WITH LOW ENERGY PROCEDURE; 

  • SUITABLE FOR LIFTING AND WRINKLES. 

LOW ENERGY TREATMENT: ($100-$200)

  • PLASMA ENERGY TOUCHES THE SKIN FOR A QUARTER OF A SECOND;

  • THE AREA OF SKIN TREATED IS SMALLER, E.G. SMILE LINES AROUND THE EYES;

  • THE DENSITY OF PLASMA SPOTS IS LOWER;

  • USED FOR CORRECTION OF SKIN TEXTURE AND DISCOLORATION;

Low energy treatments are often repeated after 3–4 times about 3 weeks apart, each requiring relatively short downtime. However, a single high energy treatment may produce more visible results than a series of low energy treatments, although it is associated with greater discomfort and longer downtime. High energy treatment penetrates far deeper into the dermis, inducing a more powerful healing response and re-modelling of collagen, tightening and contouring

Some of the conditions which may be treated by Fibroblast include:

  • Reducing excess lower eyelids and upper eyelid skin

  •  Skin imperfections 

  • Skin tags 

  •  Sunspots 

  •  Improvement in the appearance of scarring, including post-surgery scars and acne scars

  • Tightening loose stomach skin after pregnancy 

  • Stretch Marks

  •  Lines and wrinkles around the mouth

  •  Plasma facelift 

  •  Neck lift

  • Crows Feet Lines

  • Nasal Labial Folds / Laugh Lines

  • Marionette Lines

  • Wrinkle Removal

HOW IT WORKS;

During the procedure tiny plasma flash, also referred as an electrical arc is being discharged from the tip of the Fibroblast hand-piece. The tool itself never touches the skin however plasma flash creates a tiny dot upon the contact. There is no cuts, no blood. This innovative technology uses sublimation process, turning solid directly to gas to tighten skin tissue. Targeted tissue sublimate, causing no damage to surrounding areas or deeper skin layers. Further points are applied creating a symmetrical grid over the treatment area.
Fibroblast is virtually painless and doesn’t require anesthesia. Numbing cream is used to minimize discomfort during procedure. Side effects are minimal and complications rare. Carbon crusts, a tiny superficial dots which form directly on the skin are part of normal healing process. Correctly treated with after-cream will cause no threat and fall off 5-7 days after treatment. After-care instructions will be given to a patient following the procedure.
It is very important to adhere to our after-care advice.